Replace a direct-PK Belt motor

How to replace a direct-PK Belt motor?

CAUTION - MAKE SURE POWER IS TURNED OFF AT THE DISCONNECT SWITCH PRIOR TO CHANGING THE MOTOR.

    First remove the motor cover, if any.
    Remove the motor junction box cover and disconnect the motor wiring.
    Loosen the motor pulley set screw, remove the key (if applicable), and remove the wheel/propeller from the motor shaft.
    Remove the nuts, bolts, and washers securing the motor to the motor mounting plate, and remove the motor.
    Install the new motor using the four nuts, bolts, and washers. Do not tighten.
    Place the key in the motor shaft (if applicable), re-install the wheel/prop, tighten the set screw
    Align the wheel/prop and tighten the motor to the mounting plate.
    Reconnect the motor wiring, making sure the connections are made in compliance with the wiring diagram on the motor. (leave the junction box cover off at this time)
    Turn the disconnect “ON” and momentarily energize the motor to verify correct rotation. (If rotation is incorrect, turn disconnect “OFF”, adjust wiring to reverse motor rotation, and Turn “ON” to verify rotation.)
    Using motor leads in the junction box, take a correct reading with an appropriate instrument to verify that the motor is running within the nameplate amperage range and is not overloaded.
    Re-install the junction box cover.
    With fan “ON”, visually inspect that all is in proper working order.
    Replace the motor cover.
V Belt Supply - http://www.automotivedrivingbelt.com/product/automotive-v-belt/